Watson Coatings - TP Series PolyUrethane

MAGNUM SERIES	PRODUCT DATA SHEET
POLYURETHANE

TP Series PolyUrethane



PRODUCT CODE	MAGNUM
END USE	METAL PARTS, FIBERGLASS BOOMS AND OTHERS
RESIN TYPE	CATALYZED ACRYLIC POLYURETHANE
SOLVENT TYPE	AROMATIC, ESTER AND ALCOHOL SOLVENTS
VISCOSITY	TP BASE: 40-60" #2 ZAHN *
	C5141 CATALYST: 15-20" #2 ZAHN *
WEIGHT/GALLON	8.2 ± 0.2 LBS/GALLON MIXED
WEIGHT % SOLIDS	42% ± 2% MIXED *
VOLUME% SOLIDS	36% ± 2% MIXED *
SUBSTRATE	STEEL
PRETREAT & CLEAN	OVER PROPERLY PRIMED AND PREPARED SURFACES.
WET FILM	2.5-4.5 MILS PER COAT *
DRY FILM	1.0-1.5 MILS PER COAT *
FLASH POINT	86°F
GLOSS 60Â°	90+ (typical) *
THINNER RATIO	THIN UP TO 10% PER GALLON WITH RA70 REDUCER AS NECESSARY TO SPRAY. IN HOT WEATHER (OVER 80°F) USE RA80 REDUCER.
MIX RATIO	4:1 BY VOLUME (TP BASE : C5141 CATALYST)
POTLIFE	6 HOURS AT 77°F WHEN MIXED. SHORTER AT HIGHER TEMPERATURES.
DRY TIME	TACK FREE: 2 HOURS AT 77°F *
	HARD: OVERNIGHT *
	CURED: 7-10 DAYS @ 77°F & 50% RELATIVE HUMIDITY *
V.O.C.	4.73 LBS/GALLON MIXED *
CHARACTERISTICS	GOOD CORROSION RESISTANCE AND EXTERIOR DURABILITY. EXCELLENT UV PROTECTION AND COLOR STABILITY.

*	TYPICAL VALUES, VARY WITH COLOR OR CUSTOMER REQUIREMENTS.

The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this website do not constitute a warranty, whether expressed, or implied as to the product performance. Watson can guarantee this product to conform to our standards of quality, and our liability, if any shall be limited to replacement of defective materials. Any or all technical information is subject to change without notice. SEE THE PRODUCT MATERIAL SAFETY DATA SHEET (MSDS) AND LABEL WARNINGS FOR ADDITIONAL SAFETY INFORMATION.