Watson Coatings - WA Series Enamels

AQUA SHIELD	PRODUCT DATA SHEET
WATER REDUCIBLE COATINGS

WA Series Enamels

PRODUCT CODE	AQUA-SHIELD
END USE	CUSTOM FORMULATED AIR DRY PRODUCTS FOR ORIGINAL-EQUIPMENT-MANUFACTURED (OEM) PARTS.
RESIN TYPE	WATER REDUCIBLE ALKYD AND/OR ACRYLIC RESINS.
SOLVENT TYPE	WATER, GLYCOL ETHER AND ALCOHOL
VISCOSITY	DIP: 30-50" #2 ZAHN CUP *
	SPRAY: 60-80 K.U. *
BAKE TIME & TEMPERATURE	N.A.
VOLUME REDUCTION	N.A.
WEIGHT/GALLON	9.5 ± 0.5 LBS/GALLON
WEIGHT % SOLIDS	30% ± 4% *
VOLUME% SOLIDS	24% ± 4% *
SUBSTRATE	STEEL
PRETREAT & CLEAN	DIRECT-TO METAL (DTM), 3-4 STAGE WASH SYSTEM OR OVER SHOT BLASTED STEEL.
WET FILM	DIP: 3.0 ± 1.0 MILS *
	SPRAY: 5.0 ± 2.0 MILS *
DRY FILM	DIP: 0.8 ± 0.4 MILS *
	SPRAY: 2.0 ± 1.0 MILS *
FLASH POINT	GREATER THAN 180°F *
GLOSS 60Â°	AS SPECIFIED BY CUSTOMER
COLOR	AS SPECIFIED BY CUSTOMER
THINNER RATIO	THIN UP TO 10% PER GALLON WITH WATER AS NECESSARY
V.O.C.	LESS THAN 2.83 LBS/GALLON *
CHARACTERISTICS	FAST DRY PRODUCTS AVAILABLE IN CUSTOM COLORS. GOOD CORROSION AND IMPACT RESISTANCE.
*TYPICAL VALUES, VARY DEPENDING UPON CUSTOMER REQUIREMENTS AND COLOR.

The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this website do not constitute a warranty, whether expressed, or implied as to the product performance. Watson can guarantee this product to conform to our standards of quality, and our liability, if any shall be limited to replacement of defective materials. Any or all technical information is subject to change without notice. SEE THE PRODUCT MATERIAL SAFETY DATA SHEET (MSDS) AND LABEL WARNINGS FOR ADDITIONAL SAFETY INFORMATION.